Concrete Floor Stripping & Removal
When old coatings or a failing deck surface need to come off completely before new work can go down, we handle the full removal and cleanup.
Learn More
Cracked, scorching, slippery pool decks are a West Texas problem we fix every season. We resurface and coat pool decks so your backyard is comfortable and safe all summer.

Pool deck resurfacing in San Angelo, TX means applying a fresh bonded layer over your existing concrete so it looks new, feels safer underfoot, and holds up better against heat and water - and most residential jobs run one to three days from start to finish.
If your deck is cracked, stained, slippery, or so hot it burns bare feet by noon, those are not cosmetic problems - they are signs the surface has broken down and needs attention. San Angelo homeowners deal with this faster than most because the city sits on clay-heavy soil that constantly shifts underneath concrete slabs. That movement causes surface cracks to open and reopen season after season, and West Texas UV intensity accelerates the breakdown of any unprotected surface. If the problems go beyond the deck surface and extend to other concrete areas around your home, our concrete resurfacing and overlays service can address those areas in the same project scope.
If you have patched the same cracks two or three times and they reopen in the same spots every season, the soil underneath is moving. In San Angelo, clay-heavy ground swells when wet and shrinks when dry, and that cycle is relentless. Patching alone does not stop it. A proper resurfacing with crack stabilization and a bonded coating is the more lasting solution.
Bare, aging concrete can reach surface temperatures well above 130 degrees on a sunny San Angelo afternoon. If your kids are sprinting across the deck just to reach the water, the surface is absorbing more heat than it should. A lighter-colored or heat-reflective coating can make a real difference in how usable your pool area is during West Texas summers.
When concrete starts to break down at the surface level, it sheds a fine powder or small flakes - called spalling. You might notice it on your feet after walking the deck, or see it collecting near the pool edge. Left alone, spalling gets worse. Resurfacing stops the process and gives the deck a stable, sealed surface again.
Pool deck surfaces are designed to be slightly rough so wet feet grip the concrete. Over years of use, foot traffic and weather wear that texture down until the surface becomes noticeably slicker. If you or a family member has slipped near the pool, that is a safety signal worth taking seriously. Resurfacing restores the slip-resistant texture the deck needs.
We apply pool deck coatings and resurfacing systems for San Angelo homeowners whose decks have cracked, worn smooth, faded, or become uncomfortably hot in the summer sun. Every project starts with thorough surface preparation - pressure washing, grinding or etching the concrete so the new coating bonds properly, and stabilizing any cracks before anything else goes on. We also work on surrounding flatwork that connects to the pool area; if the patio, walkway, or other outdoor surfaces need a fresh bonded layer, our concrete resurfacing and overlays service handles that work as part of a coordinated project.
When old coatings or significant surface buildup need to come off before a new system goes down, we bring in the tools and process from our concrete floor stripping and removal work to strip the surface back to clean, bare concrete. That extra step matters because a new coating applied over a failing old one will fail in the same way, usually faster. We use products rated for high-UV environments and apply a UV-resistant sealer so the finish holds its color longer in West Texas conditions.
Homeowners who want a quick turnaround, a classic pool deck look, and improved slip resistance at a lower entry cost than a full overlay system.
Decks that need a longer-lasting bonded surface, with options for color, stamped patterns, or a finish that mimics stone or tile.
Anyone in San Angelo who has watched kids sprint across a scorching deck - lighter-colored finishes stay measurably cooler on hot summer afternoons.
Decks with recurring cracks caused by San Angelo's clay soil movement, addressed with flexible repair before a bonded coating is applied.
San Angelo sits on clay-heavy soils that swell when wet and shrink when dry, and that constant movement is the main reason pool decks here crack faster than in cities built on more stable ground. When you get quotes, ask specifically how the contractor plans to handle existing cracks - that question alone tells you a lot about the quality of the work you will receive. San Angelo summers also bring extreme UV radiation and long stretches above 100 degrees, which means applying coatings in direct midday heat can cause the material to dry too fast, bubble, and fail early. Experienced local contractors schedule pool deck work in early morning hours, in spring, or in fall to get the best bond and the most even cure. If you live in a newer San Angelo neighborhood with an HOA, it is worth checking your association rules before committing to a color - some communities on the northwest and southwest growth corridors have finish requirements for outdoor surfaces.
We serve pool decks throughout the San Angelo area and the surrounding communities. Homeowners in Water Valley and Christoval deal with the same West Texas clay soil and UV conditions, and we bring the same preparation process to every job across the region. San Angelo's municipal water is also moderately hard - mineral deposits from pool splash can etch an unprotected deck surface over time, which is one more reason proper sealing matters here.
Tell us the approximate size of your deck and what problems you have noticed. We respond within one business day and schedule a visit at your convenience - no accurate price can be given without seeing the surface firsthand.
We walk the entire deck, look for cracks, check for signs of soil movement underneath, and assess how much prep work is needed. This visit takes 20 to 30 minutes and results in a written quote that breaks out prep, materials, and labor separately.
The crew pressure washes the deck, grinds or etches the surface, and fills and stabilizes any cracks before any coating goes on. This step can take most of the first day on a deck with significant cracking - it is what separates a coating that lasts a decade from one that peels in two years.
Once prep is complete, we apply the coating in layers and finish with a sealer. Before we leave, we walk the deck with you in good light. The deck needs 24 to 48 hours before foot traffic and 72 hours before pool furniture goes back on.
Free written estimate. No pressure. We come to you and explain exactly what your deck needs before you commit to anything.
(325) 292-0567Newer San Angelo neighborhoods often have association rules about outdoor finishes. We ask about your HOA requirements upfront so the coating color and style you choose is one you can actually use - no surprise letters after the job is done.
Applying coatings in direct midday sun during San Angelo summers causes adhesion failures. We schedule crews for early morning starts and book projects in spring and fall when conditions favor a long-lasting cure. That is not a preference - it is how quality coatings are applied in this climate.
West Texas receives some of the highest UV levels in the continental United States. Coatings and pigments that are not UV-stable fade noticeably within a few seasons. We use products specifically rated for high-UV exposure and apply UV-resistant sealers so the finish holds its color and integrity longer. The American Concrete Institute sets the surface preparation standards we follow on every job.
You will never get a verbal price and a surprise total. Every estimate breaks out prep work, materials, and labor separately so you know what you are paying for and can compare it fairly against other quotes.
Every job we do in San Angelo comes with the same commitment: honest assessment, proper prep, and a written scope so there are no surprises. We have been working in this area long enough to know that shortcuts do not hold up in West Texas conditions - and we do not take them.
When old coatings or a failing deck surface need to come off completely before new work can go down, we handle the full removal and cleanup.
Learn MorePatios, walkways, and other flatwork around the pool area can be resurfaced with a bonded overlay to match or complement the pool deck finish.
Learn MoreCall us today or request a free written estimate online. Your deck can be ready before the summer heat arrives.